How to use OCA optical film
Time：
2023-07-06
The method of using the optical protective film is roughly as follows: 1. Preparation: Prepare an antistatic bag, screwdriver, lens remover, lens cloth or bath towel. 2. Cleaning: Use a lens cloth or bath towel to clean the surface of the lens to remove dust and fingerprints. Make sure the lenses are completely clean. 3. Prepare the optical protection: Take out the optical protection film, place it on a fairly wet hand, and let it soften. 4. Installation: Apply the protective film from the edge or corner of the lens, and smooth the folds from the center outward. Use a screwdriver, etc. to assist in removing air bubbles. 5. Heating: Use a dry cloth to stick on the protective film, gently rub and heat to help release liquid and air bubbles from the protective film. 6. Final inspection: Confirm that the protective film is completely flat and attached to the lens, without wrinkles and bubbles, and the mirror image is clear. 7. Use: When using the lens, still use the lens cloth and clean it again with steps 1~2.
光學保護膜的使用方法大致如下:
1. 準備:準備好抗靜電袋、螺絲刀、鏡頭卸下器、鏡頭布或者浴巾。
2. 清潔:使用鏡頭布或浴巾清潔鏡片表面,去掉塵土和指紋。確保鏡片完全清潔。
3. 準備光保:取出光學保護膜,置於相當濕潤的手上,讓其柔軟。
4. 安裝:從鏡片邊緣或者角落開始貼上保護膜,從中心向外平整褶皺。使用螺絲刀等協助去除氣泡。
5. 加熱:使用乾布貼在保護膜上,輕輕摩擦並加熱以幫助液體和氣泡從保護膜中釋放。
6. 最終檢查:確認保護膜完全平整貼合在鏡片上,無褶皺和氣泡,鏡像清晰。
7. 使用:使用鏡頭時仍然使用鏡頭布和步驟1~2再清潔一次。
以上大致是使用光學保護膜應注意的重點和步驟,主要是確保鏡片清晰度和保護膜貼合效果。保護膜使用一次即丟,避免重複使用。
Related news